Surface & dimensional inspection
Metallics inspection
If it is wound and a scratch is found it is a downgrade. It is a process correction, found while it runs. We show live grade and pin every defect to the meter and lane.
Metallics
If it is wound and a scratch is found it is a downgrade. It is a process correction, found while it runs. We show live grade and pin every defect to the meter and lane.
- Scratch, pit, dent, lap and rust detection - Bump
- Identification of Casting Porosity & Cold Shut
- Burr, chamfer and hole position check
CellLine scan with encoder sync for coil · switchable dark-field, coaxial and low-angle for discrete parts · vibration-isolated mount
Where the money is
Coil graded after it is already rolled
Defect mapped to metre and lane as it runs
Pays back through: downgraded coil, customer returns and re-rolling cost.
Your rupee figure is modelled from your own scrap, rework and warranty numbers during Assess & Feasibility.
| Part / Coil | Inspection result | Severity |
|---|---|---|
| CS-118 | Casting porosity | Critical |
| CL-3301 | Rolling mark | Level 2 |
| MP-402 | Burr at edge | Level 1 |
| CS-121 | Cold shut / lap | Critical |
| CL-3305 | Surface scratch | Level 1 |
| MP-407 | Within tolerance | None |
Illustrative output. Detection performance is measured on your parts during feasibility.
Start here
Send us the component.
We will let you know if it is visible.
Send 30-50 samples of your good parts, your failure modes. We do imaging trials, train a model, and come back with what we measured, including the cases where the answer is no.